L&M

To all that have pm'd thank you. I've just replied to all and included my phn#'s to better answer your questions. I have to apologize for not replying sooner but access to my computer was a bit limited this week due to some in-depth home remodeling

http://www.starbrite.com/productdetail. ... 20Cleaners

Have a good one Rod.

Somehow or another I knew that was coming. I should of warned ya 711 ps: It is a tasty chowder ask Vic (Sliderbite)

Your hired. No resume' needed

1987 29’ Penn-Yan Predator Twin 350ci 260hp Mercury Inboards. EZ-Load Tandem Galvanized Trailer Furuno 1720 Radar Radar Arch Lowrance Global Map 4000m GPS Furuno FCV 667 Sonar Standard Horizon VHF Autohelm 6000 Hyd. Auto Pilot 4 Cannon low profile bases. 2 fixed & 2 Swivel 4 Mag 20 riggers available Big-John Electric Planer Reel’s Wash down pump Bennet trim tab’s Boat is reasonably priced & set-up for the serious charter operation or rec. fishing. Survey information is available. PM me for more detailed info & pricing.

Good seein ya Coup, they'll find there way in here sooner or later. And ya ol Musky looked like an instructor I once had in school. I was waitin for a 'Swat' if I screwed-up.

I've seen you posting about this on other forums as-well with limited success. It might pay to call a few dealers and ask for the information, if per say you do need the capacity and not just the over-all weight of the boat & engine as Splitshot said above, to register it in Pa.

Andy the channel should be ok for now as it was cleaned up this last Saturday. But the wind there talking for the rest of this week might change that. As Jim said above the fishing the past few weeks has been relatively slow.

Um: I think I know Bob Have a good season & shoot a few Andy

Welcome aboard Jerry.

If it's equipped with battery isolators take a close look in that direction as well as possibly the on-board charger it self if it's still hooked up, for feed back.

If the gimbal bearing or u-joints are in question there's usually a reason for it ( IE: leaking bellows or engine alignment ). If a gimbal bearing is greased and the outdrive serviced at regular intervals they normally don't go bad with out a reason behind it. That being said it expense to repair it would be a guess until the drive is pulled.

Great job John and thumbs up to the young one's. They'll remember it for a life time.

C&P: New York State Conservationist| December 01, 1999 Kokanee have been stocked in several lakes in New York, including Long Pond, Franklin County (10,000), Polliwog Pond, Franklin County (41,600), Bug Lake, Fulton County (10,000), Mitchell pond, Hamilton County (5,000), Little Hill Pond, Lewis County (2,000), Deer Pond, St. Lawrence County (2,200), East Pine Pond, Esssex County (11,500) and Lake Colby, Franklin County (20,000). They have also been stocked to a limited extent in Lake Ontario.

Welcome aboard great lookin Browns.

Good job Bob

Some great deals on new units on e-bay. I picked up my Pro-II there a few years back for around 130 (new) at the time they were running around 200 in the stores. Only draw back with e-bay is the company wont honor the new warranty if there is a problem, unless its bought from a retailer.

Food Saver all the way here aswell.

Have a good one Bill

And as Tim said before. If it's r&c steering the rack is shot or if rotary it's the helm. Very doubtful if it's the cable.

No need to post it again on open lake cwmwnw

Good talking to ya Mike. Good luck with the boat, hunting & the atv business down there. Hank

Mike ck your pm's & give a call.

It sounds like the prop that's on it now is either cavitating for some reason or the hub is partly spun out. 120hp m/c 17' glass should be some where in the range between 15 & 17p prop as a rule if it's the original ratio drive. It should pull thru the rpm range and top out at about 4300 rpm at wot, cruise between 32 & 3400.