Shakemsam

Generally, a propane torch at the minimum is required when using heat. When that fails, try Mapp gas. A rubber mallet might be better and don't be shy with it. Pugsley's would look at it if you need. They are in Ontario, NY.

Would you consider splitting them? I am running the same 115 only a little newer..2001. That 60 degree is a great motor. Why the change? More hp?

ttt

ttt

ttt

ttt

ttt

Nice! Something to think about...I added a breaker between the battery and the console. Makes life easy when working on any console issues later. Also...12v at the back for riggers if you need and accessories like maybe a filet knife.

Wood is relatively cheap compared to Seacast or any of the other pourable's. Not to mention aluminum boats don't have sealed transoms like fiberglass. It could be done but the work involved wouldn't be worth it.

Lay the drain in splashwell and trace it out. Drill out the center with 1/8 bit. Then gradually step up to the same diameter as the drain, from the outside. Then finish it with a small sanding drum.

Be sure to re-use the inserts for the transom holes or replace with new. Coat them liberally with 5200. Keep their location in mind if you are putting the kicker directly on the transom vs a bracket. If transom, mount a piece of starboard inside the splashwell so the pressure from the kicker mount is spread out. In lew of starboard, I use black poly cutting board that I buy at Walmart. I also use it for transducer plates. Cuts easy and routs nice too and lots cheaper.

Nice Rig! Running a 90 195 Sportfisherman that I picked up a few years ago. I would imagine the transom wasn't through bolted to due the lack of access without removing all the foam. The only through bolts I have access to are the motor bolts. Keep in mind that aluminum and stainless don't mix well, just like aluminum and PT wood. Unfortunately not really any other options though. Having a good painted surface on the aluminum helps. You can also add a plastic washer as a barrier between the hull and any stainless nut, bolt head, or washer. I like your use of the Lowrance for gauges but I would be concerned with the chance of a network failure. I would have a voltmeter at a min and maybe engine temp. Good Luck!

(1 Sold) Bought these for leadcores and went a different way. Then forgot about them until today. Not linecounters but good for riggers or cores. $45 ea or 2 for $80 incl shipping

$25 shipped

$25 shipped

$20 shipped

Lure Jensen J Plugs with hooks and 4 spoons. Plug box not included. $25 shipped

It says sold on the first post.