holy mackerel

Is it possible to convert the Penn Yan to hydraulic? Then you could take the electronics from your old boat. May save you some $$.

http://www.easternmarine.com/Hydraulic-Trailer-Brake-Assemblies/

I run a 200hp. Johnson with a 3 blade aluminum prop. I installed a whale tail to improve hole shot and steering torque. The tail works well, however lost about 10 mph. I was thinking about buying a 4 blade and removing the whale tail since the 4 blade is supposed to reduce steering torque and improve hole shot. Does anyone have any feedback on performance after doing this?

http://www.nadaguides.com/Boats/2004/Yamaha/F9-9ELRC/20017486/Outboard-Motors-Values

I use them on 12# balls and have had them break. Don't think they would last with 20# balls. I don't trust them after a year or so either, I think sunlight affects them.

Don't forget to put your fly down first before pulling meat, otherwise you could have a wicked tangle.

The Ontario Fastrac doesn't have ethanol free 87 octane yet, only 91. Hope they switch over soon.

Yes, some folks like to see them and some don't.

Try amazon

ground

Some guys at my marina bought a boat last year that had been in storage and ruined the motor. Old gas and lack of lubrication. It was a v-6 I/O. I would put some oil in each spark plug hole and roll it over by hand a few times if it hasn't been started for awhile. Draw off some gas in a clear container and check it, or run it in your mower. Also, change the filter or install one if not equipped.

western red cedar or redwood if you can find it. Mine are 30 years old out of redwood. Also buy stainless threaded rod and hardware.

I always put the short line on the bottom of the spool and new 1000' on the outside with a double haywire. You don't have to worry about the knot through the guides. You just need an empty reel and a little more cranking.

Nice job Guys! Thanks! Where did all those new pirates come from? The browns are in big trouble.

lighter fluid

Simrad quit making cable autopilot a few years ago. Look into Octopus Auto pilot, they are the company that made the drive unit for Simrad. Simrad is a sister company to Lowrance and is probably why the cable steer was phased out. I have ap12 simred and it works well at all speeds. Got rid of Raymarine years ago, too many problems,very expensive repairs.

power marine in Canandaguia

Thanks!

Address? Is it on Kings highway?