Little Crappie

I'm hoping dexter pays off saturday

The kickers not left down but the highest tilt position leaves like half the prop and lower unit in the water, not much but just enough to worry me

Seeing if anyone could answer this question before I hassle the marinas. In the merc manual it says to keep the motor in gear to keep the prop from moving while on the road, but what about in the water? I'm confused cause I'd think going full speed with my main any drag would be harmful to the lower unit on the kicker? I thought it was more harmful to spin the prop while in gear, Any thought?

Inboard I'm assuming?

Totally need pictures

You by any chance have the canvas for sale for your 19.5 gls sea nymph?

I'd second that... I had a boat I sold because I just felt there was bad mojo. (Fiberglass 1980 21ft) and I still see it for sale on clist for 2 years. An survey goes a long way because a bad boat just turns into a land boat lol

Looking for a used power drive model with at least 55lb thrust, and 50inch shaft for under $500. For my 19.5 sea nymph. Thanks!

Thanks everyone but after much frustration of first trying to remove the hose, then using fish tape to thread smaller hose to no avail... I said screw it.... Bought a $20 bilge pump and threw the hose over the fuel tank and added a switch on the dask, I should add picks lol.

I need one 2 lol

Surfing lakes app for iPhone, has all the Great Lakes

There Seems to be an intrusion some where with gunk. And i cant fish the smaller hose through. Unfortunately it seams like the boat made guide holes for this one stinking hose. In a final ditch effort to keep my livewell from turning into a cooler I'm just gonna route a hose over my tank and throw a pump in that sucker and flip a switch to drain my livewell, either next week I'm fishing or the boats getting scrapped lol and I'm going to start knitting.

I'd second that, browns are a worthy fight right now and pike are right around the corner plus you don't have to go very far from shore, in addition warm water species just arnt as active or fun until their in season. Enjoy the cold water species while they last cause there like flies on s&i£.

That's funny I just went to ace and picked up 1 1/4 hose to thread through the old 1 1/2 and just use adapters! Thanks for all the help, if this doesn't work ice chest it is!

Went to take my boat out for the first season and short story after replacing wires, and batteries, my livewell drainage hose dry rotted an cracked at the dock. When I went to look at how to replace it seams this hose runs from my livewell directly under the fuel tank to the transom and nothings budging. Was wondering what the easiest war to replace. I thinking I have to remove my 5 foot gas tank I filled for first day out lol. And drill rivits out all day just to do so, at that rate might as well replace my fuel tank from 1989. I was hoping I could just pull the hose out but it seems I'm sol. Any thought?