adam2000

I think the fuses I was using weren't 30 amp. [ Post made via Android ]

The rod will not snap. We used to use noodle rods off downriggers all the time when I was younger. [ Post made via Android ]

Anyone know how mix backing I can put on this reel with 500' of copper [ Post made via Android ]

Got new 30 amp fuses today that look much stronger than the other ones. Lowered and raise re weight about 15 times. It was not in the water and only raising about 6 ft at a time but no popped fuses [ Post made via Android ]

What's 3 bucks? [ Post made via Android ]

You put brass wire on the single hook. Go on fish doctors website. He tells you how to do it [ Post made via Android ]

That hurts a little bit huh joe. You should see my hand after sunday. [ Post made via Android ]

There was no inline fuse supplied. [ Post made via Android ]

I ran the harness supplied right to the fuse box. [ Post made via Android ]

Its brand new. Used twice [ Post made via Android ]

The x4 sends a singal to a transducer. Not sure if you would need to mount it but im guess probally [ Post made via Android ]

are y talking about the aluminum riser swivel bases from cannon? i have those too. they suck, there is like a 1/4 of play back and forth on them. should of just got berts for a extra 6 bucks

thats why all them boats where out there today, lol, fished out of mexico 130-170 fow. 2-5 a mid teen king and a atlantic

the boat is miss em"s old boat. i took out where he had his plugs wired too and wired in the cannon harness. so the rigger is wired into a fuse box which is wired to a perko battery switch. i had no problems 2 weeks ago with a 12lber. pretty sure i brought it up once today and took off the blacks harness that has the 32 inch cable and then hooked the weight directly to the snap in the terminator and then when i tried to bring it up it popped the fuse, changed it and popped again. so i got out the hand crank. really need to fix this soon cause hand cranking that 15lber up from 105 down sucks. also this is the cannon coated cable from the itellitroll if that makes a diffrence

Cause I think it happened after I took the blacks release with the cable off and hooked it right to the snap on the terminator [ Post made via Android ]

Could it be because the new weight isn't rubber coated [ Post made via Android ]

Cannon says 30 amp fuse. Everyone else uses 15lb weights. I don't understand the problem. Its fine with a 12 lb [ Post made via Android ]

I just switched to a 15 from a 12 for my probe rigger andi keep blowing fuses. What size fuse do you guys use? They were 30's im pretty sure [ Post made via Android ]

But that bolt is on the boom side of the rigger [ Post made via Android ]

I switched my probe rigger weight to a 15lb torpedo. It was 12. Now my rigger pops the fuse every time I try to raise it. Its 30 amp fuse and its a brandnew mag 10 stx. Any ideas?? Bigger fuse? [ Post made via Android ]

Coated cable doesn't gave a true reading on the rigger counter. [ Post made via Android ]

The coated cable will give you a diffrent reading then what is actually out with standard wire cable [ Post made via Android ]

Steelhead are tricky to judge. Depends on how thick they are down by the tail. I have one on the wall that was 37and change and weighed just under 19 [ Post made via Android ]

Big jon. Berts transtex all are good [ Post made via Android ]