Peave

PM sent

Thanks Hank. You are the man! You are exactly correct. The other end of my cable is a molded Canon plug but didn’t occur to me it was a retrofit job. Thanks again!

Anyone have an old style Canon downrigger power connector they would sell? I am looking for both the male and female connector. Pictures are of the male end only that goes to the rigger motor. Not worried about the cord, just need the connector. Thanks.

Thanks for all the help guys. I had pins loose before but had put a small wire tie through the hole to keep it from moving. I’m not hard on my equipment so I’m just going to chalk it up to I got a bad unit. It happens in manufacturing. Sounds like lots of you have had no issues so I’m going to replace it with the same model and hope for the best.

I have two Cannon dual axis rod holders on my boat and one had a catastrophic failure yesterday. The bottom pin that holds the pistol grip in place broke through the casting. I called Cannon and was told it is out of warranty and there are no replaceable parts. My second one shows bulging on the edge at the same spot and will surely fail at some point. I asked if they had redesigned this holder since I bought mine (2014) because there is very little material between the pin hole and the edge of the casting. They promissed to check and get back to me. Has anyone else had this issue with this holder? I love how they work but don't want to buy any more unless there is more material holding these pins in place. Maybe I just got a bad batch?

Looks to me like the trailer was too short for the boat so the winch post was hitting real low on the keel. This allowed the boat to surf right over the winch post.

I used wire ties instead of screws or bolts and it works great. Thought it was going to be a temporary set up at first but 4 years later have no reason to change it.