Fishmaster 196

You can buy a 12" garmin echomap UHD for 1500.00 at cabelas right now. Last year's model but still a nice unit that will do everything you want.

https://stores.tunasreeltroubles.com/convector-cv-1/

You need to check each battery independently to see if it is good. I have a 24v system and bought group 29 size agms figuring they were better. After one year one of the battery's went bad. When one is bad it will draw the charge from the good battery and they will both drain faster than normal.

I have heard that you MAY have interference issues with it so I avoided it. Try it out and if you do rewire it separately.

Run the separate wire. I ran wire from the rear battery to a blue seas fuse panel under my dash and then connected the front graph,fishhawk and other things to that.

I started to have issues with my 2016 9.9 yammi after 4 years of flawless trolling with it. It kept stalling on me while trolling. I read where they are set to run lean from the factory due to emissions standards. There is a small aluminum cap over the fuel mixture jet/screw on the carb. You can take a small pick and pry it up and off easily. Turn the screw to open it up a little. I have not had any issues since I richened the fuel mixture a little bit.

I use it to steer and the kicker for propulsion. I lock in the heading I want to go in and can set lines and net fish when solo with no worries of getting spun around in the wind.

I have a 80lb that I use with my 9.9 for trolling. It lasts 6 to 8 hrs of trolling when set on 3.5 to 4. For bass fishing it should last all day.

Add the additional lead weight at the connection of the leadcore and your backer line so that you still have the benefit of the whipping action of the leadcore. If you add the weight at the leader end the additional weight will kill the action. You can get an additional 5ft per ounce of lead added to line at 2mph.

This reel fill calculator should get you close https://www.thesouthend.org/index.php/resources/reel-fill-calculator Sent from my LM-G820 using Lake Ontario United mobile app

Not sure what happened in your case but another member suggested to use 40lb big game for the diver to slide on due to fraying issues with smaller diameter lines. I have been using 40lb now for two uears and have not had any issues. I think you can find a kit that includes extra springs, beads and rubber tubing online somewhere. Sent from my LM-G820 using Lake Ontario United mobile app

Yes, get one. Everything Beagler Described is correct. There are are hundreds if not thousands of smaller boats on erie and Ontario that use the bow mount for the purpose you describe. Make sure you get a shaft long enough for your boat. I need a 72" shaft on my starcraft, most can get away with the shorter 60" shaft. Sent from my LM-G820 using Lake Ontario United mobile app

https://southchathamtackle.com/store/store.php?crn=209&rn=597&action=show_detail I have been using the reel winder II combo for a few years, no issues at all. Sent from my LM-G820 using Lake Ontario United mobile app