sherman brown

pm sent

i'm not sure who has it but a couple of yrs ago I seen one that you use a cordless drill to cock. but that co2 one would be even better.

i've fished in smaller. but its best to fish the weather. I fished the western basin of erie for yre in a 18' Cherokee open bow. wasnt many days we couldn't fish. it was more about comfort or storms that kept us in.

I have a pair of the big jon pro tournament that i' bought new a few yrs ago. the problems i've had is the auto stops quit working the 1st yr. I use 13# weights and the breaker on one unit kicks out at times. I contacted big jon and they gave me a name to call but I never did. I just reset the breaker and bring it on in. other than these problems they are awesome. a little fast going down for my liking but not a problem. if I had the money and was getting new it would be either big jon brutes or scotty.

we just bought one of the new Beckman nets at a bait shop in Ludington Michigan on our trip up to Manistee salmon fishing. I cant give you much info off hand but it looks great, has rubberized netting, a large enough hoop for salmon and extendable handle. it was like 149.00 but they had one for more and a cheaper one that was out of stock. Beckman nets are back by the new owner.

i'll take 3-5-6 if still available pm me payment instructions. i'll also need shipping.

another easy way to get the boat up is to start going forward about 10 mph then hit the brakes hard. the boat will slide forward just about every time. another option is to change winches. a 2 speed 3200# fulton will pull it up for you. you can get the new model which looks good or the old standard model which looks like a winch for around 145.00 on ebay.

to bad its not xl or it would be mine.

its all in how the boat loads on the trailer. when the back of the boat is floating it doesn't matter how tight you winch the boat. once the boat is pulled out off the water and the back drops down on the trailer the bow is going to drop back. the only cure I know of is to pull the boat about half way out then winch it up again. you can try not pulling back as far to load boat. both my boats do this if I pull back to far. so I just use my electric winches and winch them on up after I pull them out. I use a large turn buckle for a safety strap. my 21' boat has a 3000# superwinch with 3000# holding brakes. my 17' boat has the same winch. my other 17' boat has a 2500# winch on it. I have no winching problems at all. I got the lt3000# superwinch off ebay for around 200.00. I think the new one I just put on the 21' boat cost closer to 250.00 because it has braided rope instead of cable.

I would like to have 1.00 a lb for all the salmon i've caught on those green and chrome back in the day. always our go to plug.

I started to switch to the traxstech holders because of the 17 up and down positions for setting them. but I liked the 1 hand operation of the cannons so much better I switched back to the cannon. don't get me wrong the traxstech holders are great being able to adjust from 1 spot below level all the way up makes them one of a kind. but the cannon can be set with 1 hand. just squeeze and lower it down. makes it real nice when I have a rod in my hand. I found the cannon single axis on line for 74.00 each whereas the traxstech is around 135.00 now. the reason for the single axis is you can adjust them left to right as little or as much as you want up to 70 degrees. the double axis is adjusted from one pin hole to the next.

I like the single axis cannon holders the best. i've used the double but like the adjustment from side to side on the single axis.

i've tried buckets before. but they just never slowed me enough. I use bags now and run as slow as I want. just tie them off to the bow before launching and take them back and lay over the side until needed. drop them over the side and tie off the back of the bags. to move locations untie the backs and pull them in over the sides.