Ezsteer question

[hookedupf7]

Hey last weekend I was fishing and ez steer bar seperated on the way out. Once out it wouldn’t hold in place. Did I loose something? 

[EKoselny]

Did you check to see if the Allen screws under the white caps that tighten/loosen the bar are not too loose? That would be my first though

[hookedupf7]

Haven’t yet . Been working hood until the other day when it came apart. Going to look at that this week and try adjusting it . 

[rolmops]

5 hours ago, hookedupf7 said:

Haven’t yet . Been working hood until the other day when it came apart. Going to look at that this week and try adjusting it . 

The factory says not to adjust those Allen bolts because they are very tricky to properly set. My advice would be to count every turn when you back the bolts out, so once you put it back together you can restore the original setting. You should figure out why the rods came apart in the first place, so you can prevent it from happening again.

Edited April 30, 2023 by rolmops

[hookedupf7]

Rolmops think it may have been self inflicted. I left it hooked up and drove down the lake with kicker tilted up and motor turned opposite way the big motor did. Which pulled it apart. After I put back together back together is when problem started. I have to look at it this week. Hopefully nothing got damaged