Split copper/wire setup

[JFK]

Has anyone used a 400ft copper and tied in different lengths  100' ,200' etc. of a section of mono to connect to the inline boardso you can run different depths without having 3-4 different setups for copper/wire. Looking for ways to run depth off the boards but I have 2-400 ft copper setups along with a 300 wire. I have a couple 5 color leadcores that i am thinking  I couild use snap weights to as well. Jus trying to find a way to make a larger spread in the target zones. 

Edited March 31 by JFK

[wet the net]

The problem when trying to do this is the weighted section from the board to the boat drags down to much.  Especially the further out from the boat

[JFK]

10 hours ago, wet the net said:

The problem when trying to do this is the weighted section from the board to the boat drags down to much.  Especially the further out from the boat

Thanks. Thatis why I asked the question because I figured there was a reason and just wasn't thinking of why it could not work.