Older Cannon 10A with digital depth control

[blacksquirrel2]

I am in need of the controller for one of these riggers.They have a digital touch screen. Anybody got one they want to part with?

Thanks

Tom

[sszoldra]

I think if you send it back to Cannon they'll upgrade it to a newer model

[ERABBIT]

Digi-Troll ? Best bet if you can't get one from someone here is to go to Cannon site for Authorized Service Centers copy there phone #'s and start calling. That's what I had to do for a motor housing. They can re-wire it and make it work like a Mag10 with auto stop. If your handy you could do it yourself.

with these parts

1212386 - circuit breaker 10 amp

1296831 - Wire Jumper

2286792 - SWITCH - UP/DOWN CONTROL

drill hole for switch in housing , connect the above you can get a diagram from fish307 site.

then you will have to ground your wire on the rigger to the steel shaft that run thru the spool by taking nearly all the wire off and run a piece down into the hole in the spool against the shaft. I cut a small peice of pipe insulation down to fit it hole and hold wire against shaft. Or take it to a Service Center and they do it for $100>00 or so.

[yukonstu1]

i have a complete digi troll for sale