93 Evinrude-turn key-nothing-no trim either

[MCF]

I don't know where to start on this-took boat out-yesterday-all of a sudden you turn key nothing at controls and no trim either at controls or on engine. Have disconnected things to isolate cables to battery and trim on motor only still nothing. Battery is brand new full charge-I am thinking there is something that got disconnected on engine or an electrical component that has failed because I think by disconnecting from controls I have eliminated any neutral safety switches. Any help troubleshooting would be appreciated. It is a 93 Evinrude 40hp with factory trim and tilt.

[L&M]

Ck the main 20a fuse in the red holder near or next to the starter solenoid & main wiring harness .

[carpedium]

Did you check all of your fuses?

The next step I'd say is to remove the cowling on your engine and disconnect/ firmly reconnect each molex connector one at a time and try your tilt after each one.

[MCF]

Blown fuse-I knew there was one there somewhere just didn't know where to look.

Thanks Hank.