Tite lok triple - will it take the dipsy?

[LakerTaker85]

just purchased a pair of these and wondering if anyone has had problems with them slippin while using a dipsy rod setup?

[dewey123]

I had problems with dipsies bending the spring loaded screw for adjusting the angle of the rod holder other than that they were good

[ Post made via Android ]

[Wolfpack]

Make sure you have the little sprockets male and female ends line up or they will grind off and slip. If yours does not set at 90 degree the take the gear off the base and rotate until lines up. I carry spares and if they wear out and slip put a new one in. Make sense? Excuse my terminology but hopefully this may help.

[LakerTaker85]

haha thx wolf , i think i copy that!