Wanted CANNON DOWNRIGGER BOOMS

[LARRY200050]

WANT TO BUY TWO 6 FT  CANNON DOWNRIGGER BOOMS  FOR THE MAG 10

[lrg355]

You can use 1 inch galvanized conduit, it is 1.315 OD which is the same as Cannon booms.  Paint it black and it is an inexpensive alternative

[Crazy Train]

That's what I used, galvanized fence rails at home depot.

Sent from my SAMSUNG-SM-G870A using Lake Ontario United mobile app

[TileMan Dan]

Do you know if this would work on the stx's with the telescoping booms?

Sent from my iPhone using Lake Ontario United

[lrg355]

The holes in the body of a Mag 5 ST or Mag 10 STX will take the conduit or fencing pipe.  The pulley end tube (inner tube) on a current telescoping boom on a mag 10 STX is smaller than the pipe and needs a bushing over the pulley housing stud to fit tightly into the conduit or pipe.  On a Mag 5 ST which is the same as the Mag 10 STX except for no telescoping boom or swivel base, the pulley assembly comes with a plastic bushing to increase the stud size to fit into the 1 5/16 od tubing.  If you bought the Mag 10's new, the bushing may have been included in the parts bag even though it is not used and if you saved it you are in business.

[fishthief]

What length booms you looking for I have quite a few of them

you can contact me at either of the following

[email protected] or 850-499-5482

[TileMan Dan]

I would like 6' Just dont like telescoping booms on side riggers They tend to loosen up and slide in over the course of day.

Sent from my iPhone using Lake Ontario United

[brad379fishing]

I have 2 6' booms forsale. They are from 2 old cannon digit troll 2. You can call me at 9894641191

Sent from my iPhone using Lake Ontario United

[CHAMP99B]

tile man.....i had the same problem.....i extended the booms all the way out.....drilled a 3/16s hole in each sleeve,then screwed a stainless steel self taping screw into each sleeve....never had another problem....it will cost you .31 cents for the screws.....

[rustyrat]

tile man.....i had the same problem.....i extended the booms all the way out.....drilled a 3/16s hole in each sleeve,then screwed a stainless steel self taping screw into each sleeve....never had another problem....it will cost you .31 cents for the screws.....

This is what I did

Sent from my HTC6435LVW using Lake Ontario United mobile app