Cannon downrigger cover removal

[ReelPower]

I'm replacing power cables on two old cannon riggers. I pulled screws but the cover is still firmly attached. Anyone have some sage advice before I go caveman on the problem?

[justtracytrolling]

My old riggers did the same thing...I very carefully pried it open and it came off fine.

[ReelPower]

Roger thanks I'll take a sharp stout blade to it. Via con dios.

[pjprod]

There is a form of silicone glue on the cover...you may scratch the cover taking it off but it will come off. Just remember to use silicone when putting back together or it will leak...not good...

[ReelPower]

Thanks again some patience with the right knife did the trick.

Edited July 28, 2016 by ReelPower

[ReelPower]

There is a form of silicone glue on the cover...you may scratch the cover taking it off but it will come off. Just remember to use silicone when putting back together or it will leak...not good...

Thanks might have skipped that one by, uh, being lazy. Will do!

[generaljean]

Remove the screws from the cover.  On the opposite side of housing there is a small screw hole, put a screw driver in the hole until it reaches the other side (where the screws are that holds the cover on) and give the screwdriver a whack.  Cover should pop off.  Remove old caulk.  Don't forget to put the caulk back on before replacing the cover.  Easy Peasey.