backyard fishawk probe testing.

[rolmops]

This is simple. All you need is painters tape and a good wad of paper toweling.

Make the toweling soaking wet and wrap it around the probe making sure that the sensors on the front end of the probe are also soaking wet. Put the probe crossways under the transducer making sure that the probe antenna (that round thing in the center on top) is right under the transducer. Tape the probe up under the transducer to keep it in place making sure that there is plenty of soaked toweling between the probe and the transducer and check the screen. Its a lot simpler than big buckets and such.

Good luck.

Edited July 2, 2022 by rolmops